Bed Lift won't go all the way down

[Krackers]

Hi There, I have a 2015 Adventurer, my bed lift won't go all the way down, can't figure out why, someone did comment on the upper & lower limits need to be recalibrated, makes good sense to me but the operator manual tells me nothing on how to calibrate it, any ideas?

[Eagle5]

Greetings Krackers,
I just took a look at page 9-13 of your Owner's Manual, and I found this statement:

• The bed will also not recline unless the slideout is fully extended.

Is it possible your slideout is not fully deployed?
Could there be anything helpful in either of these two Threads?

1. Bed Problems
2. power bed lift quit

Welcome to the forum.
Eagle5

[Wayne M]

Try this:
Lippert Bed Calibration

If you find out the controller is bad you can order it from Amazon.

[Krackers]

Thanks Wayne for the info on the controller for calibration, I feel really bad asking this question, where is the controller located at?

[Krackers]

Thanks Eagle5, I did find that statement in the manual, the only issue I have is the bed is only going down 3/4 of the way then stops, it will go up all the way just not down

[Wayne M]

Originally Posted by Krackers

Thanks Wayne for the info on the controller for calibration, I feel really bad asking this question, where is the controller located at?

It depends on the day of the week and what fine craftsman decided to put it. However, it may be in a compartment on the foot or side of the bed, table headboard, etc, Look on Amazon and the link I provided for what the controller looks like, Make sure it says "Lippert Hall Effect Bed Tilt Control." The Lippert slide controllers look the same but say something completely different. They can also be purchased off of Amazon.

[Krackers]

Thanks Wayne, all it needed was calibration, works great now.

[Wayne M]

Happy to hear tt was a simple fix.

Happy trails!