I am looking for some advice on how to setup a Renogy Rover 40amp MPPT solar controller. I am running 2 6volt Gc2 batteries. They are Motomaster Nautilus brand purchased from Canadian Tire (230ah). I just installed new solar controller to replace factory PWM Go-Power 10 amp controller. I plan on adding additional panels in the near future.
I am having trouble finding the correct settings for these particular batteries. I emailed the manufacturer for a spec sheet, but my limited knowledge is making it difficult to set up controller. I have attached the "spec sheet" I was sent. Can anyone explain to me what (if any) changes I should make to the factory setting on my controller. I have it set for 12v SLD batteries currently. Just not sure if I need to adjust any parameters.
I assume that "SLD" stands for Sealed Lead Acid, and those batteries are FLA or Flooded Lead Acid. Not sealed or AGM batteries.
Other than that I'm not familiar with the Renogy charge controller or it's settings. You have the user manual and that should address charging plain old FLA batteries.
Renogy's user forum would be a great place to ask other Renogy users how to best set up the controller.
Linear Mode
