Side Cameras are reversed

hclaybass · 09-10-2020, 10:45 AM

I just bought a used 2017 Vista 30T and the side cameras are reversed-- right signal shows left side and left signal shows right side. Can I change this is the dash? was this a factory error?

Winterbagoal · 09-10-2020, 10:50 AM

You're not driving in reverse, backing up, are you?

hank857 · 09-10-2020, 11:37 AM

should be able to pull radio and change the connections. Take to an audio shop if you need help.

hclaybass · 09-10-2020, 11:45 AM

I will go check LOL

Morich · 09-10-2020, 12:23 PM

The build date of your RV and serial number make a difference on this question as they do show a change in the wiring of the cameras.
If your serial number ends in "1", This seems to show location of a camera switch. Red being the radio and the yellow item down and behind being the switch.
Click the pictures to get a better /clearer view but if you can reach it, perhaps as simple as swapping two plugs around?

hclaybass · 09-10-2020, 05:10 PM

Thanks I will look around

david1945 · 02-16-2021, 07:12 PM

Richard: I also have the Vista 31 and am contemplating installing side cameras. Right now, when I put the turn signals on my screen lights up but of course since I don't have side cameras I just get a blue screen. I have a couple of questions, where are your side cameras located? since I'm assuming that your cameras were factory installed, I would like to know how the wire gets over to the passenger side. As a retrofit, this is looking to be a bit of a challenge.

AJMike · 02-17-2021, 11:53 AM

In out Winnebago 2018 Fuse, 23T, the camera outputs tie into a single multiplexor box which is mounted behind the TV in the front. I can swing open the TV and the multiplexor/combiner box is right there, easy to reach and work on. I don't know if it is the same in your RV.

There are 3 input connectors - one for the backup camera, one for the left turn signal camera and one for the right turn signal camera according to Rear View Safety which made the combiner. According to them if the left and right connectors are reversed you would get exactly what you are seeing, so perhaps when they prepared the RV for sale they just put the screw-on connectors in the wrong sockets.