Scan Guage connect location on 27N

[dougb]

I have a Winnebago Adventurer 27N, 2019, and am trying to find the female socket to plug my Scan Gauge into. Its usually somewhere under the dash on the drivers side on most cars.
If you can direct me to it, I would greatly appreciate it. The space to move around in to get a good look is terribly limited under there. Trying to crawl under the steering wheel, in front of the drivers seat and under the instrument panel makes finding this very tough. I tried but to no avail.

[Morich]

Sorry, can't help on the location but there is one trick I might pass along for looking under the dash.
I have laid a bright light like a domed work light on the floor pointing up and then used a mirror to do some searching.
You are right that the space is not for humans to lay down and look!

[powercat_ras]

It supposed to be centered underneath the bottom of the steering col. Ford tapes it farther back on the top of the steering col. when they make a bare F53 chassis, and Winnebago is supposed to un-tape it and relocate to a more accessible place as part of coach building.

[creativepart]

Originally Posted by powercat_ras

It supposed to be centered underneath the bottom of the steering col.

That's where it is on my 2017 Adventurer. Centered underneath my steering column.

[dougb]

Originally Posted by creativepart

That's where it is on my 2017 Adventurer. Centered underneath my steering column.

Huge help on this. I will take a close look under the steering column tomorrow, with a good light.

[creativepart]

Originally Posted by dougb

Huge help on this. I will take a close look under the steering column tomorrow, with a good light.

Mine has a cover on it that snaps off and is tethered so you don't lose the cover. Perhaps yours is covered and that's why you don't recognize it.