EMS NOT Displaying Amps 2008 Winnebago Destination

[BillyT]

Just purchased A class Winnebago Destination 2008 RV and camped for couple days to get familiar with it...when had a storm roll through campground. Previously EMS panel showed amps
Thinking we had power surge, the EMS panel now didnot show any amps.
Screen went blank.
We unplugged shoreline power & replugged in.
Checked GFI plugs, and breakers.
Everything is working as should be,
We are not getting amprage reading on EMS & now cannot run generator. It does power up, but won't stay running.
Any idea what the problem can be & what I could check.
Thanks
Bill

[emiddleb]

What level of power are you plugged into? The EMS panel doesn't show amps when you are plugged into 50amp shore power. It will show amps when plugged into 30amp/20amp. Are the other lights lit on the display?

[BillyT]

Was Plugged into 30 amp. Now 20 amp at home. All other panel lights are functioning

[Ray,IN]

Sounds like the EMS unit proper has suffered a failure from the storm. I know little about the Powerline EMS system Winnebago uses. Perhaps a call to W customer service will gain some information.
I did find this: https://intellitec.com/wp-content/up...-00911-000.pdf

[BillyT]

I will check this out. Thanks..I will be contacting win/dealer service soon. I imagine they will be super busy lthis ong holiday week end.

[DancinCampers]

The EMS board should be located near your breaker panel, may need to remove cover. Should be a fuse on the board that may have blown.