Reply
 
Thread Tools Search this Thread Display Modes
 
Old 05-19-2008, 01:14 PM   #1
Winnebago Owner
 
Bob and Vicki's Avatar
 
Join Date: Oct 2006
Location: Hollywood, FL
Posts: 52
Our keyless remotes stopped working. From previus posts it sounds like I need to reprogram the remotes. Does anyone know where the keyless remote module is located on an Itasca Meridian 36?
__________________
Bob, Vicki & Lilly
03 Foretravel U320, 08 CRV
http://thetravelsofmixednuts.blogspot.com
Bob and Vicki is offline   Reply With Quote
Old 05-19-2008, 01:14 PM   #2
Winnebago Owner
 
Bob and Vicki's Avatar
 
Join Date: Oct 2006
Location: Hollywood, FL
Posts: 52
Our keyless remotes stopped working. From previus posts it sounds like I need to reprogram the remotes. Does anyone know where the keyless remote module is located on an Itasca Meridian 36?
__________________
Bob, Vicki & Lilly
03 Foretravel U320, 08 CRV
http://thetravelsofmixednuts.blogspot.com
Bob and Vicki is offline   Reply With Quote
Old 05-19-2008, 03:03 PM   #3
Winnie-Wise
 
Harry B's Avatar
 
Join Date: May 2006
Location: Central Florida
Posts: 358
In the outside compartment underneath the driver's seat. You need to remove the screws allowing the fuse panel in that compartment to swing out of the way.

On the upper right hand side is a box about 3x4 inches with a yellow sticker on it, that you have to puncture to access the programming button. This button needs to be depressed. It is a two person job as you have to turn on the ignition key and push that button to reset the code to the default setting. Once set to default setting, you can assign your own code again.
__________________
Harry
2015 Tuscany 40 KQ
2013 Honda CR-V
Harry B is offline   Reply With Quote
Old 05-19-2008, 05:59 PM   #4
Winnebago Owner
 
Join Date: Jul 2005
Location: Carmel, Indiana
Posts: 125
Sometimes I find that if I just remove the battery from the remote, then put it back in the remote starts working again. Not sure why as you would think by removing the battery you should have to then reprogram it, but this has worked at least three times for me.

Some times I think by carrying the keys and remote in my pocket, a combination of some number of presses against the control buttons occurs and some how upsets the "brain", and removing the battery resets its.
__________________
Clayton
2006 Winnebago Journey 36G
Cat 350
CWHTRAINS is offline   Reply With Quote
Old 05-20-2008, 04:09 AM   #5
Winnebago Camper
 
Join Date: Apr 2007
Posts: 14
are you sure it's not the contacts on the door jam? they are the 2 little brass balls on the jam. some times you just have to clean them off and the remote works again.
marleygirl is offline   Reply With Quote
Old 05-20-2008, 04:11 AM   #6
Winnebago Camper
 
Join Date: Apr 2007
Posts: 14
are you sure it's not the contacts on the door jam. they are the 2 little brass balls in the jam. sometimes you just have to clean them and the remote works again.
marleygirl is offline   Reply With Quote
Old 05-20-2008, 04:13 AM   #7
Winnebago Camper
 
Join Date: Apr 2007
Posts: 14
sorry for the double post
marleygirl is offline   Reply With Quote
Old 05-20-2008, 10:06 AM   #8
Winnebago Owner
 
Bob and Vicki's Avatar
 
Join Date: Oct 2006
Location: Hollywood, FL
Posts: 52
Called Jay at Winnebago. He told me that the module is under the dash pod behind the speedometer. I'll check it out and let everyone know if it worked.

By the way, our reomtes stopped working after the RV batteries ran down. Manual explains how to reset it but doesn't say where it is.
__________________
Bob, Vicki & Lilly
03 Foretravel U320, 08 CRV
http://thetravelsofmixednuts.blogspot.com
Bob and Vicki is offline   Reply With Quote
Old 05-21-2008, 07:26 AM   #9
Winnebago Owner
 
Join Date: Aug 2002
Location: Narragansett,RI
Posts: 79
On my 2004 Meridian it's located left of center under the dash cover. My module has been replaced twice, both times after trying to use it when my battery voltage was low. I was told that these modules are extremely sensitive to low voltage, so don't be surprised if reprograming doesn't work.

Paul
ppeter313 is offline   Reply With Quote
Old 05-22-2008, 04:26 AM   #10
Winnebago Owner
 
Bob and Vicki's Avatar
 
Join Date: Oct 2006
Location: Hollywood, FL
Posts: 52
Well, the module is right where it should be, under the dask cover. However, the re-program did not work. SCSFrigette tech says I need a new module.
__________________
Bob, Vicki & Lilly
03 Foretravel U320, 08 CRV
http://thetravelsofmixednuts.blogspot.com
Bob and Vicki is offline   Reply With Quote
Old 05-22-2008, 10:35 AM   #11
Winnie-Wise
 
SargeW's Avatar
 
Join Date: Sep 2002
Location: Fallbrook, Ca
Posts: 307
Be sure and follow the advice in the earlier post about cleaning the contacts on the door jamb. They are two little brass ball contacts and they oxidize from time to time. Take some steel wool and give them a good shining up. When mine starts acting up, that is what fixes it.

Sarge
__________________
Marty and Diane, Fulltiming!

Our Travel Blog www.mytripjournal.com/rvnchickalaska
SargeW is offline   Reply With Quote
Reply


Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
 
Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are Off
Pingbacks are Off
Refbacks are Off


Similar Threads
Thread Thread Starter Forum Replies Last Post
SCS/Frigette Keyless Entry Main Module BucknJeff General Maintenance and Repair 17 09-29-2010 04:55 PM
Keyless entry module location scottma General Maintenance and Repair 6 04-13-2009 07:56 PM
SCS Keyless remote -- where is the keyless controller?? rv rick General Maintenance and Repair 6 06-01-2007 10:01 AM

» Featured Campgrounds

Reviews provided by

Disclaimer:

This website is not affiliated with or endorsed by Winnebago Industries or any of its affiliates. This is an independent, unofficial site.


Copyright 2002- Social Knowledge, LLC All Rights Reserved.

All times are GMT -6. The time now is 02:20 AM.


Powered by vBulletin® Version 3.8.8 Beta 1
Copyright ©2000 - 2019, vBulletin Solutions, Inc.