No power to rear tv on 2016J View

[Mauibob56]

Rear tv not getting power. Wall switch is good. Anyone knows the location where the 12v power comes from. Wire goes into wall and to?

 

[be happy]

Heres a link to the winnebago electrical drawings. There are two listed for your model.

Table of Contents

You mentioned 12v are you sure the t.v. is not 110? Lets say its 110 you may want to check the outlet that the tv is plugged into. If you power you might check the GFCI outlet that will be somewhere in your unit, you might have two. Also check the breakers that they are all on.

As for the 12v check the fuses for that system

Alot of information is in the winnebago owners pages

Home - Winnebago

winnebago.com

 

[Morich]

drawings for 12VDC power here:

https://www.winnebago.com/Files/Files/Winnebago/Resources/Diagram/2015/15_wire_187244.pdf

Not the best info as we no longer get real schematics and have to do far more guessing but this one looks simple enough to feel I'm correct on the guess! Some of them get too many lines in one spot to know which way it went!

Out of the load center breaker or fuse, up to the power switch and then on straight up to a wall plate behind TV? Does this look like your RV?

At the load center, this fuse or breaker for Circuit JD feeds power up to the switch.

Small wires are stamped with ID near the ends of each. We can "decode" that ID with this chart:

https://www.winnebago.com/Files/Files/Winnebago/Resources/Diagram/electrical_guide.pdf

Power from load center into switch on JD and then when switched on, out on wire EX to wall plate?

Fuse good, power getting through switch, and getting all the way to TV?
The ground side of the circuit is not shown on these drawings!

See if that fits and gets it going? Shout back if there are questions or problems and we can take another look! There are two build dates of this RV but this seems to be the same for both???

Good luck on the search!