Inverter Wiring Tips? 2026 Micro Minnie 2108DS

MM-Keeper

New Member
Joined
Aug 20, 2026
Posts
1
Location
Reno
Hi all, new to RV’s but enjoying the journey so far. I have a 2026 MM 2108 and so far, I added. Torklift Box to the tongue where the old batteries used to be, 2 LiiTime 165 AH self heating batteries, Victron Bluetooth charge controller, and another Rich 200 w solar panel (planning on adding 2 more 100 w panels for a total of 600).

I’m planning on going the Victon multiplus II 3000 w inverter / charger, and putting that in the little cabinet on the side of the pass through. I know I need to replace the wiring from the batteries with heavier gauge cables but I’m looking for some guidance on best way and locations to run the wires from the tongue inside the pass through and then the best way to route to the AC / breaker area. Do I need to take off the bottom panel to do this or are there better ways or places to tie into that?

Any guidance from folks who have done this would be appreciated.
 
Happy to chat if you like separately from the forum. I did a total rewires of my 2108DS and everything fit great in the pass through with still plenty of room for storage. I put in 2 LiTime 320A mini LIpo.
 

Attachments

  • Flex New Wiring 1.JPG
    Flex New Wiring 1.JPG
    108 KB · Views: 75
  • FLX New Wiring 4.JPG
    FLX New Wiring 4.JPG
    143.1 KB · Views: 78
  • FLX New Wiring 6.JPG
    FLX New Wiring 6.JPG
    97.5 KB · Views: 76
  • FLX New Wiring 4.JPG
    FLX New Wiring 4.JPG
    143.1 KB · Views: 84

Try RV LIFE Pro Free for 7 Days

  • New Ad-Free experience on this RV LIFE Community.
  • Plan the best RV Safe travel with RV LIFE Trip Wizard.
  • Navigate with our RV Safe GPS mobile app.
  • and much more...
Try RV LIFE Pro Today
Back
Top