Ice maker water line replacement

[lenOrge]

Good Morning from a cold Cape Cod location. I have to replace the "T" in the water supply valve for my ice maker. Is there an easy way to separate the line fron the "T". It is avery tight fit, and there is not a lot of room to work with. Please help. Thanks.

 

[will stevens]

If the line is the hard plastic type, try a heat gun or hair dryer on the line to help expand the line a bit. I have had to use a heat gun to install large lines on barbed fittings before. The good news is when it cools it is nice and tight,

 

[grtharris]

lenOrge, what coach do you have??

 

[lenOrge]

lenOrge

2003 Winnebago Brave 34D. Thanks for looking.

 

[grtharris]

lenOrge, can you take a picture, some are plastic push on fittings and some are brass with compression rings and nuts.

 

[lenOrge]

Hey.....Got it done with a blow dryer, anda dabof Vasoline. Thatsfor the help and suggestions. LenOrge

 

[lenOrge]

Wow...Did I really type that. What I meant to say was that I got the T instslled with the help of a blow dryer and some Vasline. Thanks for the suggestions. lenOrge

 

[ChasA]

Len, you still misspelled Vaseline. Tee hee