Can I do a slow LifePO4 upgrade 2017 Winnebago View 24J

Thread Summary

Summarized on:
This AI-generated summary may contain inaccuracies. Please refer to the full thread for complete details.
Members widely agree that you can upgrade your 2017 Winnebago View 24J’s house batteries to LiFePO4 in stages, starting with a simple drop-in replacement and using a dedicated charger while on shore power. The consensus is that if your total lithium battery capacity stays at or below 200Ah, you can safely delay installing a DC-DC charger, as the risk of alternator overheating is minimal. However, if you plan to exceed 200Ah, most recommend adding a DC-DC charger to protect your alternator...
More...
I wouldn't expect it to be in the paperwork, as Mercedes uses more than one supplier, Bosch and Valeo to name two. The label on the Valeo on our View was pretty easy to spot, but I don't know about Bosch. Somewhere or other, the brand and electrical information has to be on it, but they don't necessarily make it easy to find.
 
Another thing to remember is that the Li-po batteries only pull high amps if they are run down.....if the are fairly charged the don't pull so much. The other factor is wire size. People that tow large 5th wheels do not have to worry about DC to DC chargers because of wire size and distance. This is why you have to drive forever to charge up the House batteries with the vehicle. I have already installed a lithium and changed the convertor in my old Class C. If I decide (in the next month or so) that it will be a problem I will just put that switch in. Or add a disconnect switch to the battery.
 
Lots of smallish points that change the answers!
Lithium has definite advantages but they are worth it to some, while not to others. So the personal view is important.
A couple biggies is that they need less watching the water and such. But AGM also reduce that work at a lower cost.
Then on the charge "profile" questions, we have choices. The lithium give us a larger amount of power available and they do last longer as we use them.
But part of that is how far we go to get them fully charged. Maybe AGM charged to 13 is good enough when compared to the expense of lithium charged to 14 volts at more expense?

A mention of the way they may react with the engine alternator may be less trouble than it sounds. They charge faster taking in more current than lead acid. That leaves them prone to overheating the alternator as we drive as the chassis and coach batteries are normally connected together while we drive.
BUT if you wanted to swap to lithium and eventually go all out, it is not necessary to do the DC-DC change right away if you do a small mod to the RV item that connects the two when we drive!
Add a simple switch in the line that controls that connection and you can do that connection when you want or not!
Consider this to protect the alternator over heating if charging lithium?
View attachment 1947514
Two differen tbuilds for that RV,so there may be some small differences when you look under there!
Under the passenger side seat you may have this setup. Large metal can has connections from chassis and coach batteries. Those contacts close when we push a dash switch to get a "jump start" for a weak starter battery. It also gets 12V on LR when we have the key on or engine runs. That 12v on the small center lug closes the contacts and goes to ground on FM!
So if you drive and DON'T want the alternator doing that to overheat, put a switch in wire LR and leave it open. Then if you ever do want it to charge after getting the DC-DC work done, flip the switch closed and it all works as designed!
Info from this drawing set for the big pictures and details:

Lots of options for going "in between" on the change.
Hi Morich - sorry to bother - I checked on Winnebago's site but can not find the wiring for my solenoid. This is what I have.. I can not for the life of me find anything similar on WB's site.
 

Attachments

  • IMG_0010.jpeg
    IMG_0010.jpeg
    94.4 KB · Views: 15
Yes, I see the problem. But it is not a biggie for the plan, just a bit confusing.
That is the mode solenoid that connect chassis and coach batteries together for charging off the alternator as we drive or to let us hit a boost switch if we need to boost a weak chassis battery for starting!
But wht you show is not what the drawings I see started with?? Maybe it got changed over the years before you got the RV? But it is not a big problem as the solenoids come in at least two different versions but do the same thing. You have a four post version, not the three post shown on drawings.
Drawings show this:
sole.jpg

On a three post solenoid battery from the dash area or ignition when the engine runs, comes down to the solenoid on wire LR att eh center lug. Inside there is a coil of wire that makes the contacts close if it gets power. Inside , that coil of wire connects to the metal case and they put a second wire FM on the mounting screw or bolt to try to make sure ground gets there!
But with teh four post type, it is all the same excpt the wire inside gets back to ground on the second small lug instead of at teh mounting screw/bolt!
Power comes in on LR, runs through the coild and comes outto meet the ground side FM on the small post instead of the mount!
See the big cable left with red marker? That is from chassis battery and yellow marked on right is coach battery cable! When power is put on LR it goes through the coil inside to meet FM. On yours type, they use a second small post isntead of going to the ground at the mounting!
Post the dash switch OR let somebody turn the key on and you can likely feel or hear this big set of contacts thump as they close? Key battery on LR from goind g to that small post and this contact will not close. If you want to keep the idea of getting a jump start for any time the chassis battery is weak, you can cut LR and put a switch in it.
Good idea to put this switch somewhere out of the way to avoid it getting turned on at the wrong time, though! A simple way, might be to just take the connection off this small lug and tape it back. Then if needing a jump start, you could untape it and put it back on the small lug long enough to start the engine. But that depends on how many tiems you need to jump start the engien and how hard it is to reach under there??
 
This is all under the passenger's seat and it's inaccessible without removing the seat, which is a pain. Installing a switch is pretty simple and the one I use has a cover that prevents accidentally turning it on. It also has a light that indicates when it's on. I mounted it where it's protected by the seat cushion.

Boost switch composite.jpg
 
One of the signs we can sometimes pick up about what history may have done? This shows what leads me to believe the solenoid has been changed. It doesn't meet the drawings but when we see different type connectors used, it tells me they were put on with different tools at different times.
a chnge.jpg


In a factory setting, it is not likely they use two different types and two different tools to crimp them!
But it doesn't change the function in any way, just makes it harder to figure!
 
One of the signs we can sometimes pick up about what history may have done? This shows what leads me to believe the solenoid has been changed. It doesn't meet the drawings but when we see different type connectors used, it tells me they were put on with different tools at different times.
View attachment 2528151

In a factory setting, it is not likely they use two different types and two different tools to crimp them!
But it doesn't change the function in any way, just makes it harder to figure!
Thank you, I got the switch installed today and it is working perfectly!
 
It's more like 200Ah or below. Above that there's a significant danger of overheating the alternator when charging the batteries from a low state of charge. As I mentioned previously, it would be helpful to know the amperage rating of your alternator.
I was finally able to find the specs for my alternator. It’s 220 amps. I installed two 12v/165ah Lifopos. I did install a cutoff switch. But wondering if i could use the alternator sometimes to charge if the Lifepos are at 13.5 volts…
 

Try RV LIFE Pro Free for 7 Days

  • New Ad-Free experience on this RV LIFE Community.
  • Plan the best RV Safe travel with RV LIFE Trip Wizard.
  • Navigate with our RV Safe GPS mobile app.
  • and much more...
Try RV LIFE Pro Today
Back
Top