Been camping most of my life and decided I wanted to upgrade. Will be talking my 1st trip with friends in a few weeks. Does any one have a "cheat sheet" for setting up and shutting down for leaving?
I took a video during my walk through and I am working on my list of things to do before, during, and after but I'm a little nervous. Any advice or help would be appreciated.
Thanks
I developed this in order to not refer to myself as a DA for forgetting or damaging something. Our rig is a 2027 Micro Minnie 2108TB. Hope it helps.
Couple of Days before departure:
RV:
Plug in home Shore Power
Turn on fridge
Put enough water in fresh water tank for a few flushes in transit
Truck:
Fuel
Fluid level
Tire condition and air pressure
WASH & clean + windshield
TOOLS:
Tire changing tools,
Jack stands
Tire repair kit
Small pancake compressor + JACKERY + jet nozzle + tire fitting
TOOL BOX + cloth bag + Electrical (checklist)
Cloth bag & electrical checklist
RV Backup Camera
INTERIOR Windshield cleaner & Exterior scrubber
Step stool
Small TAPE MEASURE for PARTNER to insure slide & utility distance.
BEFORE LEAVING ON ANY TRIP make sure your house battery switch and propane is appropriately turned off / on for your rig.
SET UP & TAKE DOWN RIG:
WALK THE SITE…CHECKING FOR
Low Hanging branches
Debri, broken glass
Obviously damaged electrical post, water spikes
Plug tester into 30 amp
If the electricity looks good, check that the (city) water works then turn it off
Check that there is enough clearance for SLIDER(s)
Check that on shore power, sewer and water connections WILL REACH
Using Beech Lane wireless level system, determine which side needs to be risen.
Put Beech Lane camper levelers in place on the lower side.
While monitoring your wireless level system app (calibrate before first trip) …LEVEL SIDE TO SIDE, CHOCK tires all the way around.
IF YOU NEED TO WEIGH the TONGUE,,,do it now
UnHITCH
STOW HITCH AND BARS
LOCK ON COUPLER
Using the wireless level app, LEVEL FRONT TO BACK.
If needed, confirm with 3’ bubbler level.
NOW put down stabilizers (don’t try to level with them)
then X CHOCK between tires
NOW LOWER & STABILIZE STEPS
PLUG IN shore power
NOW PUT SLIDER OUT
Open spigots inside the rig
Connect the water.
Turn on the water….SLOWLY AND ONLY PARTIAL.
Turn the spigots OFF. CHECK FOR interior LEAKS
NO LEAKS…TURN ON WATER FULLY
Turn ON DEMAND WATER HEATER
GLOVE UP AND INSTALL SEWER HOSE
FILL BLACK TANK half full (if using for solids)
OUTDOOR
MAT, secure mat, furniture, awning
POST SITE INFO inside your rig just in case of emergency
LEAVING THE SITE:
IF possible and needed clean and dry canopy before bringing in.
REVERSE THE PROCESS FOR EVERYTHING ELSE.