2007 Itasca Horizon HWH Rear Leveling Jack Leak: Rebuild or Replace?

Robitasca

New Member
Joined
Jun 20, 2021
Posts
2
Hi everyone
I have an Itasca Horizon 2007 with HWH jacking system with spring return.
Just jacked and noticed settling on rear left, checked it out and looks like O ring is bad. Has anyone had this issue and if yes is it worth rebuilding yourself or is it a shop job.
 
Lots of personal choic on this and different levels of hiring it done may also fit. For me, this is one I take to a shop as I am not inclined to the heavy duty work of removing the cylinder, not equipted to do what I would expect needed done. Heavy weight? Yes and I'm not up to it to take it somewhere. But if that was not t rue, I might consider fidning a shop who seems to knw what is needed and has the equipemnt to press seals in polace. There are places who repair industrial and farm hydraulics full time and they may want the job. So I call around to find them. But there may be nearby RV places who are fully setup to do this and I might let them handle that whole deal?
Lots of personal choice and different locations will have different businesses to do either.
No firm answers?
 
Perhaps some 10 years ago, I ruined my front leveling jack by not wiping it down before retracting. (lots of sand and grit had been swept onto it, and I didn't notice) Crunch, crunch, crunch, leaked plenty around the seal. Fully my fault, I always wipe them down now with longer stays or windy on sandy-dusty lots.

In any case, I bought the whole jack assembly from Amazon, free Prime shipping, $384. Disconnected the hydraulic hose, removed 4 bolts, replaced the old with the new, reconnected the hydraulic hose, ran the jack up and down a few times to move any air in the system to the reservoir, and it's been good ever since.

The rear jack will be a bit harder to reach but still do-able. Just my experience with a similar issue like yours.
 
A lot of what we do can depend on personal choices. In this case, since we can do without the jack working and some leaking, I tend to want to do more checking before spending the big bucks. If a jack was less than $500 ten years ago, I would guess near $1000 now, so I take some time to study what fits best for my area and my wallet, before deciding.
I would take some time to run the question by a few folks who do this and let them give me an estimate before jumping too high in any direction! I worked around lots of contractors with lots of hydraulics and there are lots of places to get the cylinders repaired but it takes a bit to find who does what in each part fo the country!
 

Try RV LIFE Pro Free for 7 Days

  • New Ad-Free experience on this RV LIFE Community.
  • Plan the best RV Safe travel with RV LIFE Trip Wizard.
  • Navigate with our RV Safe GPS mobile app.
  • and much more...
Try RV LIFE Pro Today
Back
Top