New Toilet for 2014 Aspect

[Michaelwpb]

I am looking into updating my toilet with an elongated one. I am looking at the Dometic 320. But cannot get good specs to see if it will fit. Has anyone done the same or can recommend a toilet that will fit.
I own a 2014 Aspect.

Thanks Michael

[Fred 2106DS]

Originally Posted by Michaelwpb

I am looking into updating my toilet with an elongated one. I am looking at the Dometic 320. But cannot get good specs to see if it will fit. Has anyone done the same or can recommend a toilet that will fit.
I own a 2014 Aspect.

Thanks Michael

Michael,

Attached is the installation manual that came with our Dometic 320. On the second page are the rough in dimensions. These are what I used when making the decision to replace our Dometic 300 with the 320 in our Micro Minnie. The critical dimension for me was the distance between the flange T-bolts to the rear wall, which is a minimum of 11". I had a approximately 1/4" to spare with my installation.

Of course, if your toilet sets at an angle to the rear wall, then you may need to make some additional assumptions, which I didn't need to make.

Fred

[Michaelwpb]

Thank you Fred for responding. I have a 3” high 2’ deep curb at the base of the wall. And I am trying to find two measurements not shown anywhere. I have 11.75 inches from the bolts to the back wall. I am looking to see if the curb will interfere. Do you know the measurements from the mounting bolts to the back bottom of the pedestal and the height of the water connection to see if they will both clear the curb. Thanks for your help in this matter

[Fred 2106DS]

Originally Posted by Michaelwpb

Thank you Fred for responding. I have a 3” high 2’ deep curb at the base of the wall. And I am trying to find two measurements not shown anywhere. I have 11.75 inches from the bolts to the back wall. I am looking to see if the curb will interfere. Do you know the measurements from the mounting bolts to the back bottom of the pedestal and the height of the water connection to see if they will both clear the curb. Thanks for your help in this matter

Michael, I'll take those measurements today and get back to you.

Fred

[Fred 2106DS]

Originally Posted by Michaelwpb

Thank you Fred for responding. I have a 3” high 2’ deep curb at the base of the wall. And I am trying to find two measurements not shown anywhere. I have 11.75 inches from the bolts to the back wall. I am looking to see if the curb will interfere. Do you know the measurements from the mounting bolts to the back bottom of the pedestal and the height of the water connection to see if they will both clear the curb. Thanks for your help in this matter

Michael,

The distance from the center of the mounting bolts to the back of the toilet base measured 5 1/8" and the height from the floor to the bottom of the water connection measured 4 1/2". Let me know if you need additional measurements.

Fred