Quote:
Originally Posted by tinglett
Ok, here's the latest. I added the solar connector and left the name generic since it should be the same for zamp vs. roof entry. I made it a PDF for printing, but hopefully it will be easily readable via the computer/phones too.
I speculatively edited the slide wiring to be what I *think* it is (including the remaining "mystery" red wire). Beware of that for now. At some point I'll pull open the control panel above the sink and see if I can verify. I'm getting pretty confident in the rest of it. Note also I only show two wheels. I figure the other two will just muddy up the drawing. I believe the wire goes to the street side wheels and then crosses over to the sidewalk side. If you happen to have your wheels off for some maintenance (or are crawling under there) let me know what you find.  While this drawing is a schematic, I'm also attempting to give physical connection/position hints as well.
PM me or reply here if you think anything is in error. I'm editing fast enough I could believe anything. Next I think I'll layer this so I can make alternative simplified variations. I want that myself for doing some solar design. Beware, I'll be asking for advice in that area soon!! |
Many thanks for the diagram. I just started getting into Solar and this helps a lot.
Linear Mode
