I just filled my water tank. after unhooking the hose at the source and turning on the water pump, water is flowing out through the outside inlet"spigot" (?) . Water flows faster when the valve is set to normal, but it also flows when the valve is set to tank fill. In either case water is not made available to the inside faucets.
Any suggestions?
__________________
Arne
2015 Itasca Suncruiser 38Q, 2008 Honda CR/V www.thesen.org
Yes, that makes a lot of sense.
Unfortunately there is only one valve for the 38Q. It has two settings: TANK FILL and NORMAL. The gushing happens for both settings.
__________________
Arne
2015 Itasca Suncruiser 38Q, 2008 Honda CR/V www.thesen.org
arneinfloria, sounds like the city water inlet check valve is stuck open, look and see if you can see the ball inside the check valve. Try pushing the ball with a small screw driver to re-seat it. A Plastic hose valve will work in a pinch.
__________________
Grant & Pat
2014 Adventurer 35P
2021 Rapid Red 4dr Bronco OBX
Yes, that makes a lot of sense.
Unfortunately there is only one valve for the 38Q. It has two settings: TANK FILL and NORMAL. The gushing happens for both settings.
if I recall the winterization valves are towards the rear of the MH in a different bay than the fresh water hookup. check your other bays.
arneinfloria, sounds like the city water inlet check valve is stuck open, look and see if you can see the ball inside the check valve. Try pushing the ball with a small screw driver to re-seat it. A Plastic hose valve will work in a pinch.
Quote:
Originally Posted by arneinfloria
Thanks. I'll try that tomorrow morning.
arneinfloria
What grtharris said.
The check valve in my water inlet looks like this: