Our 2005 Suncruiser has three slides and the one for the bed seems to be haunted. We put it fully out and on occasion, it comes in about 5 inches. The only switch is up high so cannot be accidentally pushed. What should I look for to exercise this ghost?
I had a similar problem with a front slide. It has a HWH system and I had to replace a solenoid valve. I assume you have a HWH system also. If not disregard my answer. Good luck;
Don
__________________
Don & Bev Morgan Weyauwega WI, 05 Itasca Horizon 40KD, 400 HP Cummins, Delorme GPS LT 40, Toad 07 Saturn Vue AWD, Air Force One, TST 510 TPMS, Mayor of Weyauwega 2007 - 2013, Waupaca Co Board Supervisor 2010 - 2014
I had a similar problem with a front slide. It has a HWH system and I had to replace a solenoid valve. I assume you have a HWH system also. If not disregard my answer. Good luck;
Yep, leaking solenoid. I believe in your case it would be the extend solenoid for that slide.
Thanks... now I just need to locate it Never looked for any of these before. I believe it is just behind the driver side door and is hidden by the long slide when extended. Any idea of cost of the solenoid and the difficulty to replace? I can do most work myself.
Thanks... now I just need to locate it Never looked for any of these before. I believe it is just behind the driver side door and is hidden by the long slide when extended. Any idea of cost of the solenoid and the difficulty to replace? I can do most work myself.
According to my records, in 2008 I paid a dealer to replace a "valve press solenoid (small), (131306-12-702). Part was $151.15, labor $133.00.
__________________
Paul (KE5LXU) ...was fulltimin', now parttimin'
'03 Winnebago UA 40e TRADED OFF JUL 2023 / '17 Jeep Grand Cherokee toad
Hmmm , before I would pay that, I would remove the solenoid, clean it and try again..
Also check all the connections, you may have a small leak that is letting in air..
__________________
2014 Phaeton 40 QBH
2015 GMC Sierra SLT 4x4