RV News RVBusiness 2021 Top 10 RVs of the Year, plus 56 additional debuts and must-see units → ×
 


Reply
 
Thread Tools Search this Thread Display Modes
 
Old 11-27-2019, 07:50 PM   #1
Winnebago Watcher
 
Join Date: Nov 2019
Posts: 3
removing Sony backup camera

I have just purchased a 2006 Adventurer 38J with a Sony VCB_MHD1 backup camera. after getting taillight repaired the camera did not work when I got it home. I have read posts that an inline fuse could be blown. either way I need to remove the monitor to check the fuse or replace the whole thing with another monitor or system.. can not find any manuals on the internet how to install or remove and none came with motorhome. ANY help would be appreciated.
Tumbleweed is offline   Reply With Quote
Old 11-28-2019, 09:55 PM   #2
Winnebago Master
 
Jim_HiTek's Avatar
 
Join Date: Nov 2011
Location: Full time RV'er
Posts: 889
Think that the last work done, the shop didn't do you any favors. Take it back to where you had the taillight fixed and tell them to fix the problem they caused.

The camera and the monitor are different parts of the same system. I have seen many cameras that have an inline fuse very near the camera. Which makes sense if you think about it. So pulling the monitor probably wouldn't be necessary.

But I think it's just a mis-wiring by the last tech.
__________________
'02 Winnebago Journey DL, DSDP, 36' of fun.

Visit my RV Travel & Repair Blog at : https://chaos.goblinbox.com
Jim_HiTek is offline   Reply With Quote
Old 11-29-2019, 05:04 PM   #3
Winnebago Watcher
 
Join Date: Nov 2019
Posts: 3
Thanks for the input... had problems when catalytic converter went bad, computer put rv into limp mode and Good Sam had it towed to nearest shop. while there asked to fix the turn signals. when I got home checked camera no picture, no power to monitor. the fuse in the fuse bank is not blown. The RV repair shop is over 100 miles away.


someone in this forum or one of the others forums stated the difficulty in accessing the inline fuse near the monitor. no way no how can I reach it without removing lots of stuff. there are three cameras and all are just as difficult to reach. was hoping if I could just remove the monitor I could then check for any inline fuse, check the camera, check the monitor or the wiring without removing half of the dash.
.
Tumbleweed is offline   Reply With Quote
Old 11-30-2019, 03:35 PM   #4
Winnebago Watcher
 
Join Date: Nov 2019
Posts: 2
In an earlier RV the backup camera got its' power from the white backup light in the tail light assembly. I'm thinking they may not have reattached this source of power. That's why it only turned on when in reverse ( and the backup lights were activated}.
Grady71 is offline   Reply With Quote
Old 11-30-2019, 07:47 PM   #5
Winnebago Owner
 
Cataska's Avatar
 
Join Date: Oct 2017
Posts: 117
On my 2005 itasca meridian there is a fuse in the rear of the monitor you have to remove the dash cover to get to it 8 screws i think it was.
Cataska is offline   Reply With Quote
Old 12-05-2019, 10:17 AM   #6
Winnebago Owner
 
Blkbart's Avatar
 
Join Date: Jul 2019
Location: Southern California
Posts: 73
I know that this is going to sound stupid... I had a friend's kid playing with the knobs, can't remember which one but it caused the screen to go blank. A friend came over and noticed the knob twisted, one simple twist and WORKING!
Blkbart is offline   Reply With Quote
Old 12-05-2019, 01:59 PM   #7
Winnebago Watcher
 
Join Date: Nov 2019
Posts: 3
problem solved...there are 4 screws on back side of the dash "dome".. this exposes the inside of the dash. . found the 3amp inline fuse, monitor works again.. thanks for the help
__________________
2006 Winnebago Adventurer 38J
2014 Kia
Tumbleweed is offline   Reply With Quote
Reply

Tags
camera


Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
 
Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are Off
Pingbacks are Off
Refbacks are Off


Similar Threads
Thread Thread Starter Forum Replies Last Post
Replacement of Sony backup camera and monitor Scoop Winnebago Class A Motorhomes 26 03-26-2020 11:41 AM
Sony backup display XVM-B62 Atom Ant Tech | Toys and Gear 9 06-25-2016 11:49 AM
Sony backup monitor blows fuses cwj212 Electrical | Charging, Solar and Electronics 6 10-31-2011 07:50 PM
Sony VCB-MH3 Backup Camera NR4A Electrical | Charging, Solar and Electronics 10 06-06-2010 12:39 PM
New project - laptop display on the Sony backup monitor John_Canfield Winnebago General Discussions 12 10-18-2006 05:20 PM

» Featured Campgrounds

Reviews provided by

Disclaimer:

This website is not affiliated with or endorsed by Winnebago Industries or any of its affiliates. This is an independent, unofficial site.


All times are GMT -6. The time now is 03:50 PM.


Powered by vBulletin® Version 3.8.8 Beta 1
Copyright ©2000 - 2020, vBulletin Solutions, Inc.
×