Power step

[Mike_m]

The power step on our intent 31p does not extend when I open the door. Any ideas what I should check?

[Morich]

The year can change the wire route at times so that is important info to get down to really looking but in general, I might guess that the door switch is one of the most common problems as they get kicked around, etc.
Second logic might say that there is a fuse or power problem.
If you have the big book of info there is often a good chart for troubleshooting the step.

[YGoHom]

Mine will on occasion not extend, and ALWAYS happens when I pull into a campsite! If I pull in and have to get out to look around, it will extend. When I'm finished parking and open the door to get set up - that's when it decides to stay in! It's not the switch. I think it will usually work if I start the engine again. It always pisses me off because it works ALL other times. It only happens as I pull into a site.
I think it's the Winnie's way of showing me who's really in charge.

[Wayne M]

Check the ground wire coming off the motor. It is usually bolted to the frame or other ground point on the chassis.