We have a 2006 horizon, the seat belt was replaced on the passenger side and they installed a new trim plate where the seat belt goes into the seat. I need a new one for the drivers seat (trim plate) but Winnebago cannot find the part number and it is not listed on the build sheet. Has anyone replaced this and would you have the part number? Thanks
We have a 2006 horizon, the seat belt was replaced on the passenger side and they installed a new trim plate where the seat belt goes into the seat. I need a new one for the drivers seat (trim plate) but Winnebago cannot find the part number and it is not listed on the build sheet. Has anyone replaced this and would you have the part number? Thanks
I'm not sure just which piece you're talking about, but take a look at the part diagram from the Winnie site and see if you can identify it: 2006 Itasca Horizon Parts Catalog (This is the 40fd version, but the 40kd should be the same.)
Go to DRIVERS COMPARTMENT GROUP, then FRONT INTERIOR, then COMPONENT PARTS FOR FRONT INTERIOR and see if you can identify the part you are looking for in the seatbelt diagram.
The diagram does not show the actual belt we have as our belts go into the seat. I have called Winnebago customer service and they are checking on the part for me, but they could not find it either. My next call will be to the parts department.
Good new, Winnebago called me today and the part number I gave them from the RV Parts and Accesories book is correct and they will send one to me.
If anyone needs one the part number is 153921-06-000 beige and 153921-09-000 black.
This new part is slit on the top to slide over the seat belt as the old part was slit on the side that would catch on the seat belt.
Linear Mode
