Quote:
Originally Posted by Azcal77
It is a Power Gear slide out. The broken bolts are the vertical adjustment bolts. See the attached photos.
|


. Not where mine failed. I feel for you.
The welder should be able to remove the stud from the yoke for proper surface prep. Make certain he removes the ground leads from the batteries before doing any welding.
With the slide supported, you should be able to pull the rack out and leave the yoke in place for easier access. Remove the end cover body panel to gain access to the end plate adjuster for removal.
Can't find a good picture at this moment. Weld the bolt back in place. I suggest threading a nut on it to weld to. You might upgrade the bolt to a grade 8.
Rick