On my 94 Horizon, it is behind the front step. Open the door and pull up the thread for service. You may have to remove a screw.
__________________
04 Horizon QD, 12 Ford Flex, Excalibar, Brakemaster, Winter Texan, RVin! since 1974
Norm, Donna 01 Z3
Life is a Timed Event, you only get One Go Around!
Page 2-27 of the 2004 Vectra operator manual states:
The pump is located behind an access panel in the
storage compartment on the driver side of the
coach. (It is visible to the rear of this compartment while the slideout room is extended)
On the 2005 Vectra we owned, it was located under the second step cover as one boards the MH. Under the step cover you will find a "nut". Unscrew the nut and it is directly beneath the cover. The "dip stick" is a little unusual looking.
Good luck.
On the 2005 Vectra we owned, it was located under the second step cover as one boards the MH. Under the step cover you will find a "nut". Unscrew the nut and it is directly beneath the cover. The "dip stick" is a little unusual looking.
Good luck.
Yes. Both of the top two entry steps are hinged, small nut at the very front center under the lip. You'll have to feel through the carpet to find it.
__________________
Ed & Joie
2004 Vectra 40KD
Freightliner Chassis and Cummins ISC
The reservoir is located under the third tread or the last step before the floor of the RV. I talked to Winnebago and they told me the slide outs and stabilizers use a common sump. Thanks to all who responded.
Thanks for your help. The manual was wrong but you were right.
Glad you found it, you had me worried for awhile. see post 2
And that should have been 04
__________________
04 Horizon QD, 12 Ford Flex, Excalibar, Brakemaster, Winter Texan, RVin! since 1974
Norm, Donna 01 Z3
Life is a Timed Event, you only get One Go Around!