Journey with Confidence RV GPS App RV Trip Planner RV LIFE Campground Reviews RV Maintenance Take a Speed Test Free 7 Day Trial ×
 


azpete is an unknown quantity at this point

azpete azpete is offline

Winnebago Owner

Profile Comments

Showing Profile Comments 1 to 9 of 9
  1. AndersG
    04-13-2022 06:05 PM
    AndersG
    Hi! I have been referred to you as well - I have a '99 Winniebago Vectra 39B that has the HWH levelers and slide outs. I see hydraulic fluid at both ends of both kitchen slide out rams. I am unable to fully extend or even retract using the hydraulics (If i try - only one ram retracts).. For starters - where can I find the model number?
    I've found that the tank assembly is AP2260 and the rear ram shows as part# AP17848
  2. Pappy911
    03-07-2022 09:09 AM
    Pappy911
    I was told you were the guru for HWH problems so here goes. Last use I retracted jacks(levelers) and frronts came right up. Took 15 seconds. Rears came 1/2 way up and stopped. Tried using floor jack to raise them and wouldn't budge. Had to crack lines at pump to release pressure and they came right up. Can power on system but can't extend or retract. Slide works fine off hyd system. Read manual and located fuse box velcroed to firewall but all fuses are ok. Any suggestions? 2000 Winnebago Adventurer 32V Triton V10
  3. McKenzie
    10-09-2021 10:44 AM
    McKenzie
    AZPETE I have a thread on Winnie owners Subject is slideouts, I am having a real problem an one of them told me to contact you. Could you PLEASE read the thread comments and see if there is anything you can do to help me Thank you so much, McKenzie
  4. Rickb33952
    AZPETE, I have a 2005 Itasca Suncruiser 35A with a Left Front Slide out that malfunctioned and damaged rails and hydraulics. I’m getting multiple estimates and wondered if you could help me by explaining if and how to isolate the leak so we can use the Motorhome until repairs are completed. Thanks.
  5. TGMA12
    04-07-2021 09:12 PM
    TGMA12
    AZPETE I have a Brave 34DI have a living room slide that blow a hose and maybe something on the cylinder since fluid was coming out of the tube steel i finally got it pulled in to day it went out crooked and jammed before I realized that only one side was moving I was going to take it to HWH in Moscow IA but that's a long drive from Pueblo CO is there any place near me that would understand the HWH system well enough to fix i am willing to go a few miles to get a knowledgeable mechanic.
    Thanks
    TGMA12
  6. homeless
    03-25-2020 10:08 AM
    homeless
    I understand your the guy! If you are the guy I'm sure your very busy. I have a 2000 Suncruser with Ford chassis. I have been to HWH last year twice and when the Pandemic is over plan to bring it back for this issue. I am hopping you can give me a quick tip to be able to use my slide out mean while.
    Slide started to not come in with out needing me to open the solenoid. Then close it back to be able to open it. I have been doing this for awhile. But now that trick has stopped working. And now the slide will not move at all either way, Solenoid open or closed. Motor does come on both ways so thinking its not the rocker switch. I checked and topped off fluid. And tip appropriated.
  7. pegdiver
    06-28-2019 12:28 PM
    pegdiver
    Found your profile on Winnieowners. Have a 2012 37 1/2 foot Winnie Adventurer on Ford chassis. Have Power Gear system: touch pad #140-1226, controller #1010001002. Replaces both with new. The system works on automatic but not on manual. So we can not callibrate it. Also we have no buzzer. Have talked to Lippert but they haven't helped. Have downloaded all their trouble shooting and that doesn't have our problem. (no flashing error codes). Do you have any clue what we can check? Maybe a dash systematic. Would the manual mode have something to do with the parking brake (I say no due to automatic mode working).
  8. pcfr2
    04-16-2019 06:48 PM
    pcfr2
    Hi, you were referred to me with hope to finding a solution to my HWH Slide problem.
    I have a 2004 Itasca Horizon with HWH X slide on the curb side. This slide creeps in 2-6 inches when parked. This doesn't happen all the time but more than not. Fluid good. Have run slide in and out. Any suggestions?
  9. LnG
    11-21-2018 03:17 PM
    LnG
    Afternoon, I'm Len, I posted about a slide problem I'm having on my 2005 Winnebago Journey 39f. It was recommended that I contact you to see if you might be able to help. The title of the post is "Hydraulic Slide Help Please" in General Maint. and repair. Any ideas greatly appreciated. ------ Len

About Me

  • About azpete
    City
    paulden
    State or Province
    arizona
    Country
    u.s.a.
    RV Model
    meridian
    RV Year
    2006
    RV Length
    36
    Location (City, State):
    behind the steering wheel

Statistics

Total Posts
Profile Comments
Blog
General Information
  • Last Activity: 12-06-2019 06:44 AM
  • Join Date: 06-04-2005
  • Referrals: 0

Friends

Showing Friends 1 to 3 of 5
Disclaimer:

This website is not affiliated with or endorsed by Winnebago Industries or any of its affiliates. This is an independent, unofficial site.


All times are GMT -6. The time now is 12:43 AM.


Powered by vBulletin® Version 3.8.8 Beta 1
Copyright ©2000 - 2024, vBulletin Solutions, Inc.