Hello,
I need to remove our stackable dryer and replace the heating element. I see there are two brackets holding it in place, that looks easy. My question is, is the vent hose long enough and the cord long enough to just pull out the dryer and disconnect them. The access panel next to the bed appears to only service the washer near the floor. Thanks for the help!!
Ok, got the job done with no problems and the wife is happy with having heat in the dryer again. What I did was remove the outside vent and hose clamps to the exhaust vent. I then removed the two doors on the cabinet for clearance. I used blue painters tape to cover all exposed woodwork on the door frames and shelf. Removed the six hold down screws on the front of the dryer and lifted the unit out with my wife's help. We replaced the heating element with help from U-tube video and reinstalled the unit. It was not such a bad job after all. Hopefully my description of the job may help someone else. Thanks