I have looked at a few including the popular Oxygenics but none seem to fit the space I have (limited height). I have attached a picture of my shower and where the shower head assembly attaches to the incoming water supply. Problem is that the shower head mounting of many is integrated into the attachment point. I do not have enough clearance to have the shower head mounted to the water inlet point. The original shower mounting for the sprayer is located on the other sidewall so I need one that screws into the pipe as pictured on the left but then can be mounted on the side wall where the original one was mounted (Picture on right). Open to ideas.
I'd check and see if the threaded portion showing isn't an inset that might unscrew and allow another pipe nipple or shower head be attached. Also, adaptors might be available in home improvement stores to make an Oxygenics shower head attach. We have one and it is great and a water saver.
__________________
Bob & Donna
'98 Gulf Stream Sun Voyager DP being pushed by a '00 Beetle TDI
I believe the wall holder is made by Moen so I would suspect the rest of the fixture was. You might want to see if they have a replacement that would work for you. I believe most of the shower water lines use the same size fitting so it might not be too difficult to find a replacement. Good luck,
__________________
Bob
09 Journey 39Z
Southern Ontario
We bought the Oxygenics and it comes with a wall mounted holder. I just mounted it on the side wall to the right of the water outlet. Works great for us. It comes with 2 sided tape but that didn't last long so a couple stainless steel self taping screws fixed that.
We bought the Oxygenics and it comes with a wall mounted holder. I just mounted it on the side wall to the right of the water outlet. Works great for us. It comes with 2 sided tape but that didn't last long so a couple stainless steel self taping screws fixed that.
Thanks for the reply. Which model Oxygenics did you buy?