Kitchen Aid water fitting replacement?

[Jupiter]

Originally Posted by kdmuller

Were you able to replace the valve without moving the refrigerator back? I believe we have the same problem with a new 2013 36M.
Thank You

Yes. I replaced the valve by working through the small exterior access door and removing the rear fridge panel. The fridge rear panel is fastened with around 8 hex head screws and other than needing to be a bit of a contortionist, it wasn't too bad. Once the panel is off, you can replace the valve in just a couple minutes.

good luck,
Joopy

[kdmuller]

Originally Posted by Jupiter

Yes. I replaced the valve by working through the small exterior access door and removing the rear fridge panel. The fridge rear panel is fastened with around 8 hex head screws and other than needing to be a bit of a contortionist, it wasn't too bad. Once the panel is off, you can replace the valve in just a couple minutes.

good luck,
Joopy

Joopy,
Thanks for all the info. It worked great and have no leaks. Your post was very helpful.
Thanks Again,
Ken & Judy