Leveling Micro Minnie

[RandyS]

We've got a Micro Minnie 2100BH, and were having some (side to side) leveling issues this past week.

We found that the space between the dual tires is too tight (~25" dia, 5" spacing) to put a couple of the Campco blocks next to each other to "build a ramp", and that almost all attempts to use wooden blocks just slipped out from under the tire. Sometimes the one in front of the tire, other times the one between them. Eventually, after quite a bit of aggravation we managed to get it all done with a block of wood and one of the Campco blocks on each wheel.

There *must* be an easier way.


I was looking at the Anderson system, and that could work. But on Amazon they had a lot of bad reviews of broken blocks on 1st or 2nd attempt to use them. At least there was enough of that kind of thing talked about to give me pause.

Thanks in advance for even bothering to read this.

[Fred 2106DS]

RandyS, I cut a couple inches off one side of one of my blocks so it would fit between the wheels with a full block. Put the full block against the tire you are raising and then stack however many blocks you need to get the camper level. The tire will ride up on the full block and then up on to the additional blocks. See attached PDF as an example. The red block is the shorten block and the yellow blocks are full size.

[RandyS]

Thanks very much for that Fred.

Simple solutions are pretty much always the best.