Winnebago Journey 2000. Entry door issue

[nij_tp]

Hello all, wondering if anyone who has this model could send me a couple of pictures. Very interested in the bottom, opposite side to the hinge. My door doesn't seem to shut properly and the dealer said they have fixed it but as it is new to me I dont know what correct is but it doesnt seem to be this. I hope I am wrong but have a gnawing feeling that I am not.

Thanks in advance

[Wizard]

If you could post a picture of the problem area I will look and see if I could get a picture of mine. Not sure what could have been repaired in that area.

[bsamole]

Yes, post a picture and i'll take a picture of the same area on my 2000 horizon.

[GingerNinja]

My 2000 Journey door also does not close properly. I thought it was just mine. Can you let me know how they were planning to repair it?

[nij_tp]

Not sure how well it shows but bottom of door is not flush

[bsamole]

photo of 2000 Horizon door is attached

[Wizard]

Mmine is flush. I did have a problem with rattles and added a small foam piece to the seal near the latch pin

[nij_tp]

Originally Posted by GingerNinja

My 2000 Journey door also does not close properly. I thought it was just mine. Can you let me know how they were planning to repair it?

Do you have a picture of your door?

[Ray,IN]

Our MH entry door doesn't fit evenly either. I asked about buying a new door, the service dept. said it probably wouldn't fit any better because the cab-frame was welded up that way. You can't bend/tweak a fiberglass door like you can a metal truck door so it fits the opening better. You can adjust the door "bolt" so the door fits tighter against the seal, but, it makes the door latch harder to unlatch.