No chassis power

[DBiller]

no power to rv chassis for 2013 winnebago vista,batt.shows full charge,batt.booster only clicks,used jumper cable to do a direct connect pass fuse in batt. compartment,jump from house to chassis.Nothing dealer or myself is working and I'm stuck 1500 miles from home.
Any ideas?

Thanks
[email protected]

[grtharris]

DBiller, what model Vista do you have? Are saying the engine will not start?

[DBiller]

35 B
I have house power no power to cassis.

[grtharris]

Check for 12VDC on both sides of the chassis isolation relay, if ok there move to the isolated studs mounted to the frame behind the right front wheel.

[grtharris]

Cycle the chassis battery disconnect switch a couple of times and listen for the relay.

[mel s]

Originally Posted by DBiller

no power to rv chassis for 2013 winnebago vista,batt.shows full charge,batt.booster only clicks,used jumper cable to do a direct connect pass fuse in batt. compartment,jump from house to chassis.Nothing dealer or myself is working and I'm stuck 1500 miles from home.
Any ideas?
Thanks
[email protected]

DBiller
Do BOTH your "chassis battery" AND your "house batteries" show "full charge"?
On many rigs when the "boost switch" is pressed chassis battery voltage is used to trigger/activate the "boost solenoid".
On those rigs, if/when the chassis battery voltage is to low, (depleted far enough), and/or if the chassis battery is bad, the "boost" will NOT work.
Mel
'96 Safari

[DBiller]

Problem found,relay or rocker switch is bad.
Service man ran power to back side of switch to "hot" wire for relay and it cycled to on position.
I NOW HAVE POWER AND CAN CONTINUE TRIP!!!!
Thanks for the replies

Dave

[grtharris]

Good, enjoy your travels.