Kwikee Step problem

Ron & Dee · 08-28-2011, 02:45 PM

Steps extended and wouldn't retract, then they started working ok for a few times, now the are stuck in and won't extend.

Where do I start trouble shooting?

Thanks,

Ron

Lit · 08-28-2011, 06:16 PM

Yesterday I had just about the same problem, I was thinking the battery died on me and was going to charge it. Today I went back and checked the voltage it was less then 12 volts, my battery charger registered a fault. I took it out and had a shop check it out. Turns out I had one bad cell.

tommy tucer · 08-28-2011, 06:54 PM

Hi Ron & Dee , I had a simular problem . I took apart the little contact switch on the bottom of the door ( right side ) and cleaned it up abit . The steps worked fine , but make sure you batteries are charged . When my steps went in and out without opening the door , I thought somebody was tricking me. lol . Have a good one.. Tommy Tucer Lakeland Fl.

texnet · 08-28-2011, 08:21 PM

This is the link to owners manuals http://www.kwikee.com/Adocuments.html#steps, which contain troubleshooting procedures. You just need to figure out which step you have.

This is the one that I have on my 2003 Monaco, which may be the same one for your coach since it is a 2002. http://www.kwikee.com/PDFDocuments/880OwnerManual.pdf

Ron & Dee · 08-29-2011, 06:25 AM

I haven't had time to do much trouble shooting yet, but the batteries are new, the door switch is ok, and the circuit breaker for the step us not tripped. The light under the steps works, coming on and off with the door opening and closing.

Are there any other fuses in the electrical circuit that I can check.

Thanks,

Ron

fun 33V · 08-29-2011, 10:14 AM

Our steps started acting up at the ocean the plug at the motor was loose, cleaned the connections and started working properly.

Ron & Dee · 08-30-2011, 06:34 AM

Temporary Fix

The old hammer trick, a couple of bangs and they started working

Something is hanging up somewhere

The steps started out not retracting, but would retract after slamming the door. At first I thought it was the door switch, but after they started not wanting to extend and the step light was on, I did the hammer bang on the motor and they started working.

Now to find out where the binding is located

Ron

DAB2011 · 08-30-2011, 07:17 PM

Had the same problem. I was getting power because the light was on, but the step wouldn't extend. The step had worked just minutes ago. Sooo, I took a hammmer and gave a decent rap to the motor. It has worked fine since (about a week). I don't know if it was bond up somehow or the motor is going bad. I'd bet on the later. Good luck!!

Gary CA · 09-01-2011, 07:55 AM

I also had the same issue, a wire on the inside STEP toggle switch had pulled out. Quick roadside repair made. Good luck.